Brow Lamination Tutorial

Welcome to the tutorial video of the brow lamination kit! The patch test instructions are below the video. Enjoy

 

To perform a patch test:

1. Cleanse the area where you will apply the patch test, typically on the inside the elbow but if you use strong skincare ingredients I’d recommend to apply it on your jawline.

2. Apply a small amount of the product to the patch test area (step 2 & step 3 and leave it on for 10 minutes and clean the area) and wait for 24 hours.

3. Observe the area for any redness, itching, or irritation. If there is no reaction, it is likely you can use the product safely.

 

Tint:

If you are planning to do a brow lamination and tinting, it is recommended to tint your brows after you have removed step 3 but make sure you use a SHORTER timing for the lamination as well for the tint to make sure your hairs do not get overprocessed.

Also it’s worth noting that the front of the brows is typically thicker than the tail. As a general guideline, we recommend reducing the timing by 2 minutes for the tail of the brows, as there is usually less hair in that area.After tinting you can go on to clean the brows and apply the nourisher.

Regarding the waxing/plucking of the brows: please do this AFTER the treatment.

Terug naar blog